Bravo G4 17 / Bravo G4 22 / Bravo G4 28
EN
5
1.5. INTENDED USE
The product described in this manual is only intended for sterilisation of reusable surgical instruments and materials.
DEVICE INTENDED FOR PROFESSIONAL USE
The use of the device is strictly reserved to qualified personnel. It must never be used or handled by untrained and/or unauthorised
persons.
The device must not be used for the sterilisation of fluids, liquids or pharmaceutical products.
The steriliser is not a mobile or portable device
1.5.1.
IMPORTANT NOTES
Information contained in this manual is subject to change without notice.
The manufacturer is not responsible for direct, indirect or accidental damage resulting from or relating to the provision or use of this information.
This document may not be reproduced, adapted or translated, in part or in full, without the prior written permission of the manufacturer.
1.6. GENERAL WARNINGS
When using this product,
always
follow the instructions in the manual and never use it for anything other than its intended purpose.
The user is responsible for any legal requirements relating to the installation and use of the product. The manufacturer will not be held
responsible for any breakage, malfunction, property damage or injury to people in the event that the product is not installed or used
correctly, or proper maintenance is not carried out.
Please observe the following precautions in order to avoid injury or property damage:
•
Use ONLY demineralised / distilled water of high quality (IF THE DEMINERALISATION FILTER IS NOT PRESENT IN THE FILLING TANK).
The use of water of inadequate quality can severely damage the device.
See technical characteristics appendix in this regard.
•
Do not
pour water or other fluids on the device;
•
Do not
pour flammable substances on the device;
•
Do not
use the system in the presence of flammable or explosive gases or vapours;
•
Before performing any maintenance or cleaning intervention,
ALWAYS DISCONNECT
power supply.
Whenever it is not possible to disconnect the power supply
from the device, or if the external mains switch is distant
or not visible to the maintenance technician,
place a “work
in progress” sign on the external mains switch after having
turned it off.
•
Make sure the electrical system is grounded according to current laws
and/or standards;
•
Do not
remove any label or nameplate from the device; request new
ones, if necessary.
•
Use
only
original spare parts
.
Failure to comply with the above exempts the manufacturer from all liability.
