Page 65
STAT
IM 2000/2000S
Service Guide
96-106775 Rev 5.0
3. Troubleshooting Cycle Faults
STAT
IM
5000/5000S/5000 G4 Service Guide
Troubleshooting Cycle Faults
There are three types of cycle fault formats that can be seen on all STATIM 2000 and 5000 Classic
and G4 units. They are as follows:
1. Cycle fault numbers and descriptions appropriate to
ONLY STAT
im
2000 non S units with
revision 3.x and 4.x type controller boards.
• Typically, these will show a number preceded by “
Check Cassette
”.
• The display on the LCD screen will NOT show any software revision and will display
“
SELECT A PROGRAM
” when switched on.
2. Cycle fault numbers and descriptions appropriate to
ALL STAT
im
2000 and 5000 units with
revision 2.x/5.x/6.x and 7.x type controller boards
with revision 1.xx/2.xx/4.xx/5.xx and 6.xx
software as appropriate.
• These units will show a number preceded by “
CF
”.
• When the unit is switched on, a
software revision number
will be displayed for a short
time on the top, right hand side of the LCD display (for example
S2S2R415
), depending
on type (2000/5000), model (S or non S) and controller type.
3. Cycle fault
descriptions only
with no fault number. These are generic faults that do not
necessarily occur as the result of a mechanical or electrical failure of the STAT
im
unit but of a
process error.
After identifying the unit you are trying to diagnose, refer to the following
troubleshooting guides
to assist in the diagnosis.
