Color I: Adjust the tonal characteristics of Reverb I. When turned clock-wise the tone of the
reverberation will become brighter with a longer 'tail'.
Level II: Adjusts the overall amount of reverberation for Reverb II.
Color II: Adjusts the tonal characteristics of Reverb II. When turned clock-wise the tone of the
reverberation will become brighter with a longer 'tail'.
Loudness: Adjusts the overall volume of the amplifier.
OFF/STBY(Standby)/ON switch: 3-Way switch: down is OFF, middle is Standby, and up is ON.
About Standby: Standby mode mutes the sound and allows the tubes to heat up before
applying high voltage to amp when turned ON. Leave in Standby for 30 seconds to a 1 minute
before switching ON. Standby can also be used to mute the amplifier while leaving the tubes
warm for short breaks. For long breaks it is best to turn the amplifier completely off.
To turn OFF, follow the same turn-on procedure – but in reverse order – allowing the amp to
idle in Standby mode for about 30 seconds before powering down. While it is perfectly okay to
turn the amp OFF immediately, idling in standby before powering down lets the filter
capacitors inside the amp fully discharge. If turned off immediately, there will still be some
sound as the filter caps continue to discharge, which may be annoying.
Note: Amps fitted with the Ghost Effects Loop will experience a short delay when switching from
Standby to ON. This is normal.
Indicator lamp: Attractive red neon light to indicate the amp is ON.
Rear Panel
WARNING: Use with grounded power outlet only! Discard power cord immediately if ground
pin is damaged/broken. The ground connection is for your safety in case of a fault condition!
120 VAC power input: Plug in the included standard IEC power cord here. For use with120 VAC
only unless otherwise specified. Canadians, you are good to go too!
Fuses
WARNING: Only check/change fuses with amplifier unplugged from the outlet!
Your amp is fitted with fuses for safety and to protect the amplifier’s most expensive parts.
2
