ASSEMBLY INSTRUCTIONS:
1) Assemble the stand per instructions provided in the box.
2) Remove the trinocular head from packaging and insert, bottom side first, into
focus assembly ring. Tighten screws in order to secure microscope body.
3) Remove the eyepiece covers on the microscope head and insert the eyepieces
included. You may place the rubber eyecups on eyepieces if desired.
4) Unscrew the protective cap on the bottom of the microscope head and attach the
ring light adapter or any auxiliary lens included for desired
working distance and magnification (see diagram on next page).
5) Secure the appropriate ring light to the lens attached in step 4 by tightening screws
on ring light. Plug in the Fiber Optic Ring Light to the Fiber Optic Illuminator,
and plug the illuminator to an outlet.
6) Remove cap from video port on trinocular and attach CCD adapter. Screw CCD
camera onto CCD adapter, threaded face plate should be facing operator for
proper orientation of image.
7) Plug the 12-pin connector into the “DC IN” portion of the CCD camera. The 12-
pin connector splits off into two different cables, one a S-Video cable the other a
power supply converter. Plug the power supply converter into an outlet and the S-
Video cable into the “S-VHS IN” port located on the back of the monitor or to a
PC frame grabber. Plug in the monitor to an outlet.
OPERATING INSTRUCTIONS:
1) Adjust the height of the microscope head to reach appropriate working distance
according to lens attached in step 4, see table below for working distance.
2) Adjust the distance between the eyepieces in order to fit your inter-pupil distance,
this is complete when the image is one complete circle. Place a sample under the
microscope, turn zoom knob to its greatest setting (4.5) Focus the image by turning the
focus knob on the focus assembly on the stand. Once image is in clear focus at its highest
magnification you may zoom out to lower magnification while remaining in focus.
3) If image does go out of focus when zooming out, zoom to the lowest setting and focus each
eyepiece by adjusting the dual diopter adjustment under eyepieces (one at a time).
4) For video viewing mode, slide the video switch bar to the “PHOTO IN” position in order
to divert the image through the CCD camera and onto the monitor. Focus image on
screen by adjusting the fine focus ring located at the back of the CCD adapter (do not use
the focus assembly on stand, doing so will cause eyepieces to be out of focus). Adjust gain
and color by adjusting knobs on the CCD camera. Please remember that while in video
mode, only the left eyepiece will be functioning.
EYEPIECES
0.3X
0.5X
0.75X
RA
1.5X
2X
ALL
287
177
117
100
47
26
WORKING DISTANCE (mm)
AUXILIARY LENS
CCD camera
CCD camera
adapter
Fiber optic
Illumination
Boom stand
Monitor
SZ
SZ
-
-
PK6
PK6
-
-
05 Shown
05 Shown
Match your auxiliary lens to your working distance
Eyepieces
Video port
Zoom knob
Diopter
adjustments
CCD adapter
