15
Setting Up
Setting Up
Setting Up
Setting Up
Setting Up Y
Y
Y
Y
Your R
our R
our R
our R
our Remote
emote
emote
emote
emote
Your universal remote is configured from
the factory to control your set-top. In
addition, you can program your remote to
control most TV and VCR models, as well
as various additional devices.
Your remote requires two AA batteries
(included). Alkaline batteries are recom-
mended. If the light on the remote flashes
twice whenever you press a key, the
batteries are weak and should be replaced.
Use the following procedure to replace the
batteries.
CAUTION:
Make sure you correctly align the
positive (+) and negative (-) terminals
on the batteries to the corresponding
terminals in the remote control.
1. Press forward and lift the lever on the
back cover of the remote control. The
battery cover releases, and then you can
pull up the cover to remove it.
T6434
2. Remove and safely dispose of the old
batteries.
3. Insert and firmly seat two new AA
batteries (alkaline recommended) into
the battery compartment.
T6435
4. Slide the battery cover back onto the
remote control, and snap the cover into
place.
