25
Setting Up Channel Control
By default, the channel keys on your
remote (CH+, CH-, digits 0-9 and Last)
allow you to change channels on the set-
top, the TV, or a VCR, depending on the
current mode. You can disable or enable
channel control for the TV or VCR mode.
Also, if you have reassigned your AUX
key to control a second TV or VCR, you
can disable or enable channel control for
that device as well. See
Reassigning
Mode Keys
earlier in this section for more
information.
If you disable the channel control for a TV
or VCR, then the channel keys in that mode
will control channels on the set-top.
To disable channel controls in a mode (so
that the channel keys always control the
set-top):
1. Press one of the following key
combinations until the light blinks
twice:
• To disable channel controls for a TV,
press
SELECT
and
TV
at the same
time.
• To disable channel controls for a
VCR, press
SELECT
and
VCR
at
the same time.
• To disable channel controls for both
the TV and the VCR, press
SELECT
and
CBL
at the same time.
• To disable channel controls for a TV
or a VCR that is assigned to the AUX
mode key, press
SELECT
and
AUX
at the same time.
2. Using the keypad on the remote, press
9 9 7
.
3. Press
CH -
. The light blinks twice to
confirm the change.
To enable channel controls in a mode (so
that the channel keys in that mode control
the appropriate device):
1. Press one of the following key
combinations until the light blinks
twice:
• To enable channel controls for a TV,
press
SELECT
and
TV
at the same
time.
• To enable channel controls for a
VCR, press
SELECT
and
VCR
at
the same time.
• To enable channel controls for both
the TV and the VCR, press
SELECT
and
CBL
at the same time.
• To enable channel controls for a TV
or a VCR that is assigned to the AUX
mode key, press
SELECT
and
AUX
at the same time.
2. Using the keypad on the remote, press
9 9 7
.
3. Press
CH +
. The light blinks twice to
confirm the change.
