30
1. Refer to your VCR user’s guide to
locate the IR sensor window. (The IR
sensor is where the VCR receives the
remote control signal.)
2. Remove the covering on the adhesive
strip from the loop tape, which is
attached to the hook fastener on the IR
Blaster.
Notes:
• Attaching the IR Blaster to the VCR
may be easier if the loop tape
remains attached to the hook
fasteners.
• After attaching the IR Blaster to the
VCR, the hook and loop fastener
allows you to easily remove the IR
Blaster for cleaning or to move the
VCR.
Attaching the IR Blaster to Your VCR
3. Mount the IR Blaster within 3 inches of
the IR sensor on your VCR by pressing
the IR Blaster against your VCR to
secure it.
Notes:
• Locations A , B, C, and D are the
typical places where the IR Blaster
can be attached (within 3 inches of
the IR sensor on your VCR).
• Do not block the tape insert door on
your VCR.
