Scientific Atlanta AT8560 AllTouch, User Manual

8

Program the Remote to Control My Devices 

Your remote is initially programmed to only operate your set-top. The Volume and Mute 
keys will not work until a TV code is programmed into the remote. If the remote provides 
only limited functionality for a device, you can look for a code that provides more 
functionality. Before you begin, make sure you know the brand name of the device you want 
to control.

Note

: Some remote keys may be assigned to operate one device type only. For example, 

volume control may be assigned to the TV only. If this is the case, you can reprogram 
power, volume, and channel control using procedures later in this guide.

Assigning a Different Device Code to a Mode Key

1.  Find the codes for your brand of device in the appropriate setup code list at the end of 

this guide. For example, look under

 TV Group

 if you need to program the remote to 

operate your TV. 

2.  Turn on your device.
3.  Press and hold

 SELECT

 and the appropriate mode key until all of the mode keys 

blink twice. For example, to set up the TV, press and hold

 SELECT

 and

 TV

.

Note

: If you reassigned mode keys, you may, for example, press

 SELECT

 and

 VCR

to program the VCR mode key with a TV code. 

4. Enter the 

Þ

 rst setup code for the device. All mode keys blink three times to indicate 

that the code entry was accepted.

5.  Point the remote at the device, and press

 POWER, PLAY

, or 

 to test the 

device.

6.  Did the device operate correctly?
 • 

If

 yes

, write down the code that worked on the cover of this guide.

  You may need it again if the device code is accidentally erased.

 • 

If

 no

, repeat these steps using a different setup code.

Note

: If none of the codes listed for your brand of device operate the device correctly, 

go to

 What If None of the Codes Work

 for instructions.

7.  Repeat this procedure for each mode key you want to program.