Chapter 5 Viewing Alarm Messages
Alarm/Reference/Detail Description
Alarm: Qam Card <X>:
Configuration
Ref: ITU and FPGA mode do
not match
Detail: -
Contact your Scientific Atlanta.
Alarm: Configuration file
Ref: QAM Encoding Type
missing from configuration
file
Detail:
If the QAM Encoding Type parameter is missing from the
configuration file then this alarm is raised. A Scientific Atlanta
representative should be contacted.
Range Errors
The following table contains the range errors.
Alarm/Reference/Detail Description
Alarm: Qam Card <X>:
Configuration
Ref: Frequency Output <Y>
out of range
Detail: FR <Min> <Max>
<actual>
There is a frequency range in which the Continuum DVP Dense QAM
Array 24 device works. This alarm is raised and the RF Output of the
QAM card in question is switched off if the frequency is outside of
that range. The frequency should be set to be inside the support range.
<X> represents the QAM card number and <Y> the RF output
number.
Alarm: Qam Card <X>:
Configuration
Ref: Output level out of
range
Detail: OP Lev <Min>
<Max> <actual>
The output level has been set out of range. The output level is set to
the minimum or maximum value. Set the output level between 45.0
and 55.0 to clear this alarm.
<X> represents the QAM card number.
Alarm: Qam Card <X>:
Symbol rate
Ref: Symbol Rate out of
range
Detail: SR <Min> <Max>
<actual>
The symbol rate has been set out of range. During this alarm the RF
output of the QAM card in question is switched off. Set the symbol
rate between 5.0 and 5.5 (ITU-B and ITU-C) or 5.0 and 7.0 (ITU-A) to
clear this alarm.
<X> represents the QAM card number.
Alarm: Qam Card <X>:
Configuration
Ref: Channel Spacing
Output <Y> out of range
Detail: CS <actual> <Min>
<Max>
The channel spacing has been set out of range. Set the channel spacing
to 6 (ITU-B and ITU-C) or 7 or 8 (ITU-A) to clear this alarm.
<X> represents the QAM card number and <Y> the RF output
number.
Alarm: Qam Card <X>:
Bandwidth
Ref: Insufficient channel
bandwidth
Detail: Required BW
<actual> <Max>
This is a warning to show that the bandwidth exceeds the channel
spacing. Decrease the symbol rate to clear this alarm.
<X> represents the QAM card number.
60
4018055 Rev B
Summary of Contents for Continuum DVP eXtra Dense QAM Array 24
