•
Lo
wer Alarm:
All
ows you to enable and configure, for each channel, a lower alarm setpoint.
o
Hysteresis:
Allows you to configure a hysteresis for the lower alarm for each channel.
•
Upper Alar
m:
Allows you to enable and configure, for each channel, an upper alarm setpoint.
o
Hysteresis:
Al
lows you to configure a hysteresis for the upper alarm for each channel.
•
Offset:
Allows you to make small adjustments to the readings for each channel. The configured offset will be added to all readings perfor
med on
the configured channel.
CUSTOM CALIBRATION
The
icon open the custom calibration screen, allowing adjustment of up to 10 measurement points for each channel. The minimum nu
mber of
adjustment points, wh
en a custom calibration is configured, is 2 points.
NXperience
Figure 5 –
Custom Calibration
•
Measured:
Device read value for which a correction is desired. It can be obtained from the device by clicking on the "Read Channel" button or
manually filled in.
•
Desired:
Desired value for the device measured value. It must be filled manually.
•
Read Channel:
Makes it possible to obtain the values directly from the device during a Custom Calibration.
•
Add:
Inserts the "
Measured" and "Desired" pair into the Custom Calibration table.
•
Modify:
Allows you to modify the "Measured" and "Desired" pair in the Custom Calibration table.
•
Organize
•
Delete
:
Allows you to sort the Custom Calibration table.
:
Allows you to delete the selected line from t
he Custom Calibration table.
•
Delete All
:
Allows you to clear the entire Custom Calibration table.
•
Apply:
Applies the custom calibration to the channel being configured.
•
Cancel:
Cancels the Custom Calibration operation.
22/65
