SCM Microsystems GmbH, Oskar-Messter-Straße 13, D-85737 Ismaning, Tel.: +49 (0)89 9595-5000
Document ID: MANUAL_SPR532, Version 1.30
Date: 07/04/2006
- Technical data subject to change without notice -
2.2
Hardware
The SPR532 is delivered with a hybrid connector, which enables you to attach the reader to the serial or USB
interface by plugging in the appropriate cable. The serial as well as the USB adaptor must be connected to the
reader before attaching it to the PC. The adaptor cable must not be exchanged when the device is connected to
the PC.
serial adaptor
USB-adaptor
Fig. 2.1: adaptor cable
2.2.1
SPR532 Serial
If you are working with the serial version of the SPR532, shut down and switch off the computer before attach-
ing the smart card reader. Never attach or remove the device during operation as it may cause permanent damage
of your PC or SPR532.
Connect the SPR532 hybrid cable with the serial cable supplied with your smart card reader. Attach the serial
plug of the cable to the serial interface (COM port) of your PC. Put the PS/2 plug between the keyboard and the
PC. This connector is required to power the smart card reader. If you now start the PC, Windows
®
will recognize
the SPR532 automatically and load the appropriate driver.
2.2.2
SPR532 USB
Connect the SPR532 hybrid cable with the USB cable supplied with your smart card reader. Plug the black USB
type A connector into one of the PC’s free USB connectors. Windows
®
will recognize the SPR532 automatically
and load the appropriate driver. If your PC has no more USB ports available, you can use a USB hub to extend
the number of USB ports. Please note that active hubs require their own power supply.
