SCM eHealth100, Manual

3.2.2 Installation Test

It is possible to check if the installation of the eHealth100 terminal was successfully done with
the help of the installation test. 
Please go to Start 

➝

All Programs 

➝

SCM Microsystems Tools 

➝

Installation Test.

A new window "Installation check Program" opens. You will be able to understand if drivers
where installed, what drivers were installed, if the slots were installed correctly, et cetera. 

A final result - if the installation was successful or failed - will be shown at the end of the list.

An installation protocol with the name 

InstallTest.log

will be created when the window will be

opened. The log file includes the same data as listed in the window and will be saved at
Programs\SCM Microsystems Tools\InstallTest\InstallTest.log. 

If there are any problems arising during the installation of the MKT+ driver, please send an
email with the log file to eHealth@scmmicro.de.

4. I

MPLEMENTATION

Make sure the casing and the seals on the underside of the terminal are intact before using
the terminal for the first time. Please contact your dealer or SCM Microsystems directly if you
suspect manipulation. 

First connect the appropriate connection cable (serial or USB). Afterwards, connect the 
device's power supply with a 230 Volt / 50Hz power socket. Insert the cable plug into the
appropriate socket at the back side of the terminal.

One or two seconds after plugging in the power supply you will hear an acoustic signal. The
start sequence takes a few seconds with changing LED displays. The terminal is ready for
use if the basic display shows the icon "Menu". 

Note:

Only the power supply shipped with the device should be used, as other supplies might
damage the terminal. 

11

- Click Install to start the installation process. 
- A new window will show the installation status: 

- Wait until the installation is finished and the following window appears: 

- To open the "Readme" file, please check the box indicated. Now click Finish to 

successfully complete the installation. Now connect the eHealth100 to the system.

10