2B
RF KEY - Installing The Battery
3
Positioning Of Smart Switches
60-90%
80-95%
20-60%
0-10%
80-90%
brick walls
wooden contructions
with plaster boards
reinforced concrete
metal
regular glass
Transmission of radio frequency signals through various materials
Transmitter requires one 3V (CR2032) battery
1. Remove the cover from
the underside using a
small screwdriver to
reveal the PCB
2. With a screwdriver unclip
the right hand side to
allow the PCB to tilt up
and slide in the battery
ensuring correct polarity
3. Carefully push down
the PCB so it clips in to
the original position
Note: Please dispose of old batteries utilising your local waste recycling centre.
If not known then please contact your local authority for information on a recycling facility
in your area that will take your used batteries.
4. Re-fit the cover and cover
screw. DO NOT OVER
TIGHTEN THE SCREW
Scolmore Park, Landsberg, Lichfield Road Industrial Estate, Tamworth, Staffordshire B79 7XB
Tel: +44 (0) 1827 63454 Fax: +44 (0) 1827 63362
www.scolmore.com
V1.0
For more information, please refer to the ‘Installation Guidelines’ leaflet supplied with the receiver.
Incorrect battery installation can cause damage to the battery strap and invalidate the warranty