Page
5
of
21
Important Information
When using electrical appliances, basic safety instructions should always be followed.
-
Read all instructions before using the UbiDuo 3.
-
To protect against risk of electrical shock, do not put the UbiDuo 3 or its cord or plug in water or other
liquids.
-
Do not operate either side of the UbiDuo 3 with a damaged cord or plug, or after either side has been
damaged in any manner. Contact sComm Tech Support if the UbiDuo 3 is damaged in any way.
-
Do not let cords touch hot surfaces and where possible, do not let cords hang over the edge of a table, desk
or counter.
-
The use of accessories not recommended by the manufacturer may cause fire, electric shock or injury.
The UbiDuo 3 is designed and manufactured to be rugged and durable, however it should still be treated with the
same care one would give to a laptop computer. Do not drop it, do not spill liquids on it, and do not unscrew any
part of the UbiDuo 3 to remove the casing.
Only use the UbiDuo 3 power cord to charge the units. The UbiDuo 3 charger operates on 120 volts AC; if you are
traveling overseas, you will need an appropriate converter.
Separating the Two Halves of the UbiDuo 3
To separate the two halves of the UbiDuo 3 without damaging the internal parts, always lay the UbiDuo 3 on
a flat, hard surface such as a desk or a table.
Grasp the two blue mental hinges and pull them away from each other (as seen below).
Follow the same manner in putting the UbiDuo 3 back together by using a flat, hard surface. When you push
the blue mental hinges into their slot you will hear or feel a click to let you know the device halves are
securely together.
