sComm UbiDuo, User Manual

 
Compliance Statement (Part 15.19) 

This device complies with Part 15 of the FCC Rules.  
Operation is subject to the following two conditions:  
1.   This device may not cause harmful interference, and  
2.   This device must accept any interference received,  
       including interference that may cause undesired operation. 

Warning (Part 15.21) 

Changes or modifications not expressly approved by the party  
responsible for compliance could void the user’s authority to  
operate the equipment. 
 

FCC Interference Statement (Part 15.105 (b)) 

This equipment has been tested and found to comply with the limits for a Class B 
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to 
provide reasonable protection against harmful interference in a residential 
installation. This equipment generates uses and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, may 
cause harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If this 
equipment does cause harmful interference to radio or television reception, which 
can be determined by turning the equipment off and on, the user is encouraged 
to try to correct the interference by one of the following measures: 
  - Reorient or relocate the receiving antenna. 
  - Increase the separation between the equipment and receiver. 
  - Connect the equipment into an outlet on a circuit different from that   
     to which the receiver is connected. 
  - Consult the dealer or an experienced radio/TV technician for help. 
 
This portable transmitter with its antenna complies with FCC’s RF exposure limits 
for general population / uncontrolled exposure.  
 

Specific Absorption Rate 

This portable equipment with its antenna complies with FCC's RF radiation 
exposure limits set forth for an uncontrolled environment. This equipment has 
shown compliance with FCC's Specific Absorption Rate (SAR) limits. To maintain 
compliance, this transmitter must not be co-located or operating in conjunction 
with any other antenna or transmitter. 

Industry Canada CS03 Statement 

“NOTICE: 

 The Industry Canada label identifies certified equipment.  This 

certification means that the equipment meets telecommunications network 
protective, operational and safety requirements as prescribed in the appropriate 
Terminal Equipment Technical Requirements documents(s).  The department 
does not guarantee the equipment will operate to the user’s satisfaction. 

Before installing this equipment, users should ensure that it is 

permissible to be connected to the facilities of the local telecommunications