Fitting the Canopy frame
5.
Ensure both
M8 handwheels
on the
spigot
are fully tighten. Also check to ensure both arm
rests are fully secure and fully tightened by using
the
M8 handwheels
located underneath the
scooter’s seat.
1.
On the face of the
spigot
,
equally loosen off the two
M8 handwheels
with six
full turns.
2.
Ensure that both washes
are spaced away from the
face of the spigot and are
positioned against the
M8
handwheels
.
3.
On the Canopy frame turn
the arm supports so that
they are pointing away to
the sides in relation to the
frame.
4.
Slide the main Canopy
frame on to the
spigot
in
between the washers and
the face of the
spigot’s
plate.
16
Summary of Contents for Canopy
