11
Insert the hot wire in the slit of the smaller cap.
Then, tighten onto the body of the connector.
Remove the cap on the open end of the Quick
Connector attached to the white wire of the
installation harness. Insert the switched power wire
of the vehicle into the slot in the cap. Tighten the
cap back on to the Quick Connector.
White:
Install this wire to a 12 volt
switched source using the provided
Quick Connector.
For example:
the tail light or license plate
light power wire.
1.
2.
Summary of Contents for RIDE CORE
Page 1: ...1 core powered by ...
Page 5: ...7 Components Core Quick Connector GPS Antenna Hook Loop Cable ties Harness ...
Page 17: ...19 ...
Page 18: ...20 ...