Installation
Components List
MCM (Main Control Module)
Remote Transceiver
Accessory Harness
Generic Installation Kit (GEN-1)
Main Harness (HAR-1)
Planning the Installation
It is very important that before starting the installation of the security system, you carefully read
the installation instructions and spend time planning the installation. By planning ahead you will
be able to select the best approach in placing, securing and wiring the system to your specific
motorcycle. Although the installation is not difficult, there are a number of steps that must be
taken for the system to operate properly. We suggest the following steps:
1.
Check that your motorcycle battery is fully charged and that all electrical circuits are in
good working condition.
2.
Check the layout and construction of the motorcycle to decide what space is available to
place the components.
3.
Verify that no moving parts interfere with the components or their wires.
4.
Do not route wires near sharp edges, which could cut wires and cause a short.
5.
Do not mount components near extreme heat areas such as exhaust pipes etc.
6.
Allow at least an inch or two of slack at all connection points to reduce the chance that a
connection will break apart due to vibration.
2
