PAGE 15
These machines have a white "CE" Decal on them that Identifies the machine and has other
important information such as machine Voltage, Hz, RPM, Weight & Year of Manufacture.
This Decal is located on the black cover on the motor side of the machine, under the START &
STOP buttons. You will need this information for ordering parts or service for the machine.
An example of what the CE Decal looks like below:
4.3 MACHINE IDENTIFICATION
CAUTION: TO PREVENT DAMAGE TO THE MOTOR AND DANGER TO THE OPERATOR,
ALL ELECTRICAL CONNECTIONS MUST BE MADE BY A LICENSED ELECTRICIAN.
The AL150 HS is available 240V and 440V Three Phase. Single Phase is NOT available. To ensure
satisfactory machine performance, the supply voltage should be +/- 10% of the motor voltage rating.
Check the motor data tag for full load current requirements. The electrical diagram for the motor is
inside the cover of the motor box.
For electrical supply lines ten feet (3 m) or shorter, we recommend at least 12 and preferably, 10 gauge
wire. For longer supply lines, use at least 10 gauge and preferably, 8 gauge. We do not recommend
supply lines longer than twenty five feet (7.5 m).
POWER REQUIREMENTS:
Motor: CANTONI 3SIEK112M12
MOTOR VOLTAGE FULL LOAD AMPS
230 13.0 Amps
460 7.5 Amps
230 (Single phase) Not Available
Motor power rating: Approx. 4.75hp Motor rpm: 3500
Grinding Belt Pulley rpm: 4300
KVA power rating: 4.6 KVA at 60 Hz
Starting Current: 210% Full Load
4.4 ELECTRICAL REQUIREMENTS
Additionally, the machine Serial Number is
located on top of the tube clamp on the left side.
FIGURE 5
ALMI
Motor
Type
AL 150 HS
Volt
230
Hz.
60
l/min
4300
Weight
275
2019
Sr.No.
Summary of Contents for AL150-HS
Page 2: ...PAGE 2 MODEL AL150 HS HIGH SPEED PIPE NOTCHER GRINDER...
Page 11: ...6 2 3 5 7 8 FIGURE 2 4 1 PAGE 11...
Page 19: ...PAGE 19 COVER SWITCH PLUNGER COVER SWITCH PUSHER HINGED COVER FIGURE 8 REAR COVER SWITCH...
Page 21: ...FIGURE 9 MODEL AL 150 HS 1 2 3 4 5 6 7 8 PAGE 21 9 ITEM 7 DETAIL CONTROLS ADJUSTMENTS...
