PAGE 22
6.0 MACHINE OPERATION
CAUTION: MAKE SURE ALL GUARDS AND COVERS ARE IN PLACE
The switches are located on top of the machine above the guard on the motor side of machine.
To START the machine, push the GREEN button.
To STOP the machine, push the RED button.
REFER TO SECT. 5.0 SEE FIGURE 7
6.1 STARTING AND STOPPING BELT
6.2 DRIVE FOR THE GRINDING BELT
A pulley with a rubber coating is mounted to a bearing housing with a shaft on the deburring end
of machine . This shaft is driven by the motor via a cogged belt and toothed pulleys. The rubber
coating on the pulley that drives the belt, in combination with the correct belt tension, ensures the
required grip of the grinding belt to the pulley.
Usually the direction of rotation is indicated on the grinding belt. Even though this machine is
designed to reverse the rotation of the belt, it is recommended that the belt be installed to go with
the rotation for notching.
6.3 SECURING A TUBING SECTION
The clamp for the tubing has V-shaped side plates on the left side and is suitable for clamping
tubing with a diameter of 18 - 76 mm (3/4 - 4-1/2 in).
ITEM 6 in FIGURE 9 is the handle to operate the tubing clamp.
When the V-shaped side plates are removed, the tubing clamp can also be used to secure
rectangular and square tubing. In the case of rectangular and square tubing, the center of the
tubing profile must be at the same height as the center of the grinding roller. To achieve the
correct height of the tubing profile, a fill block can be used under the tubing section.
ITEM 7 in FIGURE 9 shows an allen bolt that is used to set the angle of tubing clamp. There is
also another bolt (not shown) in the center of this clamp.
6.4 ANGLE ADJUSTMENT
Summary of Contents for AL150-HS
Page 2: ...PAGE 2 MODEL AL150 HS HIGH SPEED PIPE NOTCHER GRINDER...
Page 11: ...6 2 3 5 7 8 FIGURE 2 4 1 PAGE 11...
Page 19: ...PAGE 19 COVER SWITCH PLUNGER COVER SWITCH PUSHER HINGED COVER FIGURE 8 REAR COVER SWITCH...
Page 21: ...FIGURE 9 MODEL AL 150 HS 1 2 3 4 5 6 7 8 PAGE 21 9 ITEM 7 DETAIL CONTROLS ADJUSTMENTS...
