FIGURE 14
DEBURRING GUARD
SEE FIGURE 14 BELOW
If a large number of parts are being deburred, or if a grinding a large amount of material from a part is
required, it is recommended that the extra deburring cover for the notching end of the machine is used.
This cover is stored on the motor side of the machine below the motor and electrical cover. It is "hung"
on to the pillar and just lift up on it to remove it from the pillar. SEE FIGURE 14A
It mounts with a built in slot in front of the notcher roller as shown in FIGURE 14B.
After it's mounted, the hinged clear cover should be rest on top of it as shown in FIGURE 14C.
FIGURE 14A
FIGURE 14B
FIGURE 14C
PAGE 28
Summary of Contents for AL150-HS
Page 2: ...PAGE 2 MODEL AL150 HS HIGH SPEED PIPE NOTCHER GRINDER...
Page 11: ...6 2 3 5 7 8 FIGURE 2 4 1 PAGE 11...
Page 19: ...PAGE 19 COVER SWITCH PLUNGER COVER SWITCH PUSHER HINGED COVER FIGURE 8 REAR COVER SWITCH...
Page 21: ...FIGURE 9 MODEL AL 150 HS 1 2 3 4 5 6 7 8 PAGE 21 9 ITEM 7 DETAIL CONTROLS ADJUSTMENTS...
