Page 31
1.
Before powering the saw, check the oil level in the reservoir (A). There is a sight glass in the
back of the reservoir. The head must be in the full UP position. Use a SAE 10W (ISO 32)
non-foaming hydraulic oil, such as Mobil DTE 10 or equivalent.
2.
Slide the shuttle valve (C) to its CLOSED position and connect the air supply.
3.
Slide the shuttle valve to its OPEN position and shut the flow control valve off. Then open it
one turn.
4.
The down feed rate is adjusted using the flow control valve (B). The down feed rate should
be set during the setup of an operation while the AUTOMATIC/MANUAL switch is in the
MANUAL position. The setting of the down feed rate is done by sound. Slowly adjust the
rate as the saw makes a cut. Once the blade starts to chatter or the saw starts to load up,
back off
by a 1/4 of a turn.
Many things, including the type of material being cut, the blade RPM and the condition of
the blade, will affect the down feed rate.
CAUTION: ALWAYS DISCONNECT THE AIR SUPPLY BEFORE REMOVING THE
FILLER PLUG FROM THE RESERVOIR. IF THE FILLER PLUG IS REMOVED WHILE
THE MACHINE IS CONNECTED TO AIR PRESSURE, THE FLUID IN THE TANK WILL
BE PURGED THROUGH THE OPENING UNDER PRESSURE.
Summary of Contents for CPO-315-HFA-CNC
