4.4 ELECTRICAL REQUIREMENTS
PAGE 14
CAUTION: TO PREVENT DAMAGE TO THE MOTOR AND DANGER TO THE OPERATOR,
ALL ELECTRICAL CONNECTIONS SHOULD BE MADE BY A LICENSED ELECTRICIAN.
POWER REQUIREMENTS
Motor frame 3PH=182T 1PH=184T
MOTOR VOLTAGE FULL LOAD CURRENT
(VAC)
(AMPS)
208 14
230 12.6
380 7.7
460 6.3
575 5.1
230 (single phase) 24.5
Motor power rating: 5hp Speed 1,725 RPM
KVA power rating: 5.6 KVA Frequency 60 HZ
Starting Current: 210% Full Load
All machines are wired for three phase electrical power unless otherwise specified by customer. The
supply voltage should be (+ or -) 10% of the motor voltage rating, to insure satisfactory machine
performance. Check the motor data tag for full load current requirements.
The electrical diagram for the machine is inside the cover of the control box.
SEE DIAGRAMS IN FIGURES 4A THRU 4D
For electrical supply lines ten feet (3 m) or shorter, we recommend at least 12 and
preferably 10, gauge wire. For longer supply lines, use at least 10 gauge and preferably, 8 gauge.
We do not recommend supply lines longer than twenty five feet (7.5 m).
Summary of Contents for FI-8510-20M
