Page 12
5.5 GENERAL RULES AND SAFETY CHECKS
Before using the machine, check the efficiency and perfect operation of all safety devices and check
that the moving parts of the machine are not blocked, that there are no damaged parts and that all
machine components are positioned and work correctly.
All safety devices must be kept in working order.
DO NOT operate this machine without the protective shield in position.
ALWAYS wear gloves and protective eyewear.
ALWAYS wear regulation work clothes that are not loose fitting and are fastened.
Before operating the machine, the operator must ensure that all tools used for maintenance or
adjustment have been removed.
In the event of a fire, use powder extinguishers and disconnect the machine from the electric system.
6.0 RECOMMENDATIONS AND MAINTENANCE
6.1 TYPE AND FREQUENCY OF INSPECTIONS
The operator’s knowledge of the machine is one of the best ways of daily control of any possible problem.
If any failure is detected, work must be stopped and qualified personnel must be informed immediately.
NOTE: ALWAYS CLEAN THE MACHINE AND THE WORK AREA AT THE END OF THE
WORKDAY.
Summary of Contents for GAA-500-90 CNC DT20
