Scotchman GAA-500-90 CNC DT20, Manual

TABLE OF CONTENTS

1.0 INTRODUCTION

1.1 Legislation applicable to the planning and construction of the machine.

1.2 Warranty

2.0 GENERAL MACHINE DATA

2.1 Machine identification data.

2.2 Technical data.

2.3 Electrical data.
2.4 Noise level.

3.0 INDICATIONS REGARDING TRANSPORT AND STORAGE

4.0 INSTRUCTIONS FOR ANCHORING AND SERVICE START-UP

4.1 Anchoring instructions.
4.2 Power supply connection.

4.3 Instructions regarding blade installation.
4.4 Cutting coolant.

4.5 Pneumatic oil.

5.0 INSTRUCTIONS FOR USE

5.1 Proper and improper use.

5.2 Function of the operating mechanisms.

5.3 Manual mode.
5.4 Auto mode.
5.5 General rules and safety checks.

6.0 RECOMMENDATIONS AND MAINTENANCE

6.1 Type and frequency of inspections.
6.2 Qualified personnel for maintenance and repair work.

6.3 Possible breakdowns.
6.4 Manufacturer recommendations.

7.0 DRAWINGS AND SCHEMATICS

8.0 MAIN FRAME ASSEMBLY
9.0 SHUTTLE FEED SYSTEM

10 . OPTIONAL CHIP COLLECTOR - WIRE LOCATIONS

1. INTRODUCTION

This instruction manual has been made in compliance with the requirements of the Legislation according

to the Machine directive 2006/42/CEE and its subsequent amendments.
The instruction manual represents an integral part of the machine. It must be consulted before, during

and after the machine is put into service, as well as whenever it is considered necessary, thereby

respecting the content in each and everyone of its parts.
This is the only way in which the fundamental objectives that have been established on the basis of this
manual will be achieved, such as accident prevention and making optimal use of the machine features.

Within the framework of this manual, all aspects regarding safety and accident prevention on the job

Page 2

2
3
3

4
4

4

4
4

5
5
5

5

6
6

6
7
7

7

9
9

12
12
12

14

14
15

16

22
24

26