Page 10
5.3 OPERATING CONTROLS
A. This is the parts counter. This must have a value on it in order for the machine to run in the
automatic mode.
B.
This button starts the automatic operation. Button J starts the saw motor.
C.
This is the hood open switch.
D.
This is the hood open indicator light. When this light is illuminated, the saw will not operate.
E.
This is the emergency indicator light.
F.
This is the power to the machine indicator light.
G.
This is the E-Stop.
H.
This is the shuttle feed rate adjustment.
I.
This is the blade feed adjustment.
J.
This is the motor start and stop switch.
K.
There are two K buttons. These buttons are used in the manual mode to make a trim cut. Both
buttons must be pushed and held to make the saw blade advance.
L.
This is the switch for the vertical clamps.
M.
This is the switch for the horizontal clamps.
N.
This switch stops the automatic operation of the machine.
O.
This switch selects either the manual mode (center position) or automatic mode. You have two
choices, of a single hitch or a double hitch, for the automatic mode.
Summary of Contents for GAA-500-90 NF
