Page 20
6.4 MANUFACTURER RECOMMENDATIONS
In the event that the machine is broken down or the saw blades must be replaced, place a padlock
on the protection switch and place the keys under the care of qualified personnel.
Before working on any electrical devises, disconnect the plug from the power supply.
If extension cords are used, ensure that the cable has the appropriate cross-section for the power
of the machine.
Whenever any part has to be replaced, use an original replacement part and endeavor to use the oil
recommended by the manufacturer.
Once a month, all of the chips in the saw should be thoroughly cleaned out. This includes blowing
out chips from the motor fan guard.
Once a month, check the motor belt for any wear.
Once a month, grease the bearing hub.
NOTE: In case of any doubt or problem, do not hesitate to consult the manufacturer.
ATTENTION! The manufacturer hereby guarantees the supply of each one of the parts or
components for at least 3 years from the manufacturing date of the machine.
ATTENTION! The manufacturer is not responsible for breakdowns caused due to the improper use
of the machine.
Summary of Contents for GAA-500-90 NF
