Page 8
5.0 INSTRUCTIONS FOR USE
5.1 PROPER AND IMPROPER USE
This is an automatic cut-off machine, especially designed for cutting aluminum profiles. The use of the
machine for cutting other materials is hereby prohibited. Such use may cause damage to the machine and
put the health and safety of the worker at risk.
DANGER! We are not responsible for any possible accident caused by the failure to comply with the
aforementioned.
5.2 FUNCTION OF THE OPERATING MECHANISMS
Indicator lights:
Green:
Power supplied to the machine
Red:
Emergency
Yellow:
Protective shield lifted
Saw blade, on-off: On, green colored symbol I. Off, red O.
Emergency button with interlock. It stops the machine completely, thereby
keeping the material tight in the hold-down clamps.
Lift protective shield: Only in manual mode.
2 green push buttons, for raising the saw blade; only in MANUAL MODE.
1 black push button, hold-down clamp operation; only in MANUAL MODE.
1 black push button, feeder gripper; only in MANUAL MODE.
Advance, blade raise and feeder speed regulator.
Operating mode selector:
O - MANUAL MODE
I - SINGLE ADVANCE SPEED
II - DOUBLE ADVANCE FEED
Summary of Contents for GAA-500-90 NF
