Page 57
7.11E HEAVY DUTY SPLIT RING RETAINING NUT
SEE FIGURE 26 BELOW.
The heavy duty split-ring retaining nut is used in oversize punching applications that require a punch
with a 2 inch (50mm) shank diameter. This retaining nut is provided with a brass billet screw in the
threaded section. After the punch and die alignment is completed by following instructions in SECTION
6.1, tighten the brass billet against the ram threads. Remember to loosen the brass billet before removing
the retaining nut. This retaining nut requires a pin wrench, which should be ordered when ordering the
nut.
To use the heavy duty split-ring retaining nut, remove the six socket head cap screws (D). Slide the
retaining ring (C) over the punch shank. Place the split-ring (B) into the groove on the punch. Place the
ring nut (A) on the punch and replace the six socket head cap screws (D).
FIGURE 26
Summary of Contents for IRONWORKER 6509-24M
