When operating the PressPro 110 it is best to have the cylinder located in the center of the press and then
place the work piece on the table in alignment with the press ram. If this is not possible, reposition the
cylinder to achieve the best alignment.
Use extreme caution when performing a press operation on parts that can possibly fly off, break
(especially cast parts and hardened parts) or bounce up as a result of the force being applied. In this case,
a proper guard must be installed around the work piece or the operator should stand at a safe distance.
After correct placement of the work piece, pressing force can be applied.
Page 29
6.0 OPERATING THE PRESSPRO 110
CAUTION: ALWAYS WEAR THE APPROPRIATE PERSONAL PROTECTIVE EQUIPMENT.
THIS INCLUDES SAFETY GLASSES, SAFETY SHOES, AND EAR PROTECTION.
AVOID LOOSE FITTING CLOTHING TO PREVENT INJURIES.
When you are finished operating the press:
•
Return the piston back to its upper position.
•
Position the cylinder back to the center of the machine.
•
Turn off the hydraulic unit.
•
Clean the machine and working area.
► NOTE: UPWARD MOVEMENT OF THE PISTON IS ONLY ALLOWED FOR ADJUSTMENT
OF THE TABLE OR RETURNING THE RAM TO ITS START POSITION. ANY OTHER
USE OF THE RETURN STROKE SUCH AS STRETCHING OR PULLING SOMETHING
APART CAN CAUSE THE PRESS TO MALFUNCTION AND/OR CAUSE INJURY TO
PERSONNEL. USING THE PRESS IN THIS MANNER IS STRICTLY PROHIBITED.
