PAGE 11
Note: never run the press when its low on oil. This will damage the hydraulic
unit and cause the press to malfunction.
The machine must be connected to 220V 3ph or 440V 3ph power.
The electric circuit must be protected by a fuse or circuit breaker with an adequate rating.
The motor direction can be changed by swapping (2) of the incoming phases (SEE BELOW).
NOTE: check if the turning direction of the motor is in the direction of the arrow,
looking at the motor from above. THE WRONG DIRECTION CAN DAMAGE THE
MACHINE IN A VERY SHORT TIME!!
3.7 Electrical connection
PAGE 11
4. Functions of the press
Fig. 7 Overview of controls
4.1.1
On / Off
Switch
4.1.2
Emergency
Button
4.1.5
Pressure
Regulation
Valve
Oil Filler
Plug
4.1.3
Direction Control
Valve / Joystick
4.1.6
Speed Setting
Valve
4.1.7
Hand Pump
Summary of Contents for PRESSPRO 176MT
Page 20: ...PAGE 20...