Page 10
7.0 TROUBLESHOOTING/CORRECTIVE MAINTENANCE
PROBLEM
POSSIBLE CAUSES
The machine does not start.
Check that the main switch is connected to the power supply.
Motor fuse has blown.
2A fuse has blown.
The rear arc guard has not activated the safety micro-switch, or this is
not working properly.
Check the operating contactor, start-up control and transformer.
Bad quality or out-of-square cut.
Tension too low or too high. See Section 5.3
Condition of the cutting saw.
Coolant liquid used. We recommend pure, synthetic coolant
mixed 7 to 1 with water.
Condition of the blade guide plates.
Guide adjustment. See Section 7.1
Excessive wear on blade.
Tension too low or too high. See Section 5.3
Guide plates worn.
Excessive pressure from upper plate. See Section 7.1
Downwards feed in high or batch cutting.
Quality or pitch of blade unsuitable for the material or section to be
cut.
Coolant liquid used. We recommend pure, synthetic coolant mixed 7
to 1.
Noises when saw rotates.
State of belt guides. See Section 7.2
Excessive tension in cutting saw.
Bearings no. 26, 46 Figure 10.3
State of the cutting blade.
The pressure gauge does not
Top up with hydraulic oil (viscosity 32); to do so, the pressure gauge
reach 100 bars.
must be removed.
Check for oil leaks. State of internal flanges.
Tensing mechanism. Flywheel and bearing.
Summary of Contents for SU-280-G
