Installation
This manual covers several models of remote
cubers. The model number on the ice machine can
be found either on the dataplate, which is on the
back panel, or the serial number tag, which is
behind the front panel. See the illustration for the
locations of the dataplate and the serial number
tag.
The remote condenser has a separate model and
serial number. Its model and serial number is on
the dataplate on the condenser near the quick
connect fittings.
Write the model and serial numbers here:
Model
Serial Number
Ice machine
Bin
Condenser
Write the day of start up here:
_______________
Switch Bezel
All models ship with the On and Off switches front
accessible. if desired, the On and Off switches can
be covered up to prevent unauthorized use by
changing the bezel in the front panel's trim strip. A
cover up bezel ships loose with the machine.
See the label on the front panel for instructions on
changing the bezel.
Uncrate and Set Up
Begin with the ice storage bin or dispenser. If a bin,
remove the carton, and, using part of the carton as
a cushion, tip the bin on its back to remove the
skid. Attach the supplied legs or optional casters.
Return the bin to a normal, upright position.
Check the bin top gasket for rips or gaps. If
recycling an older bin, replace the gasket or repair
with food grade sealant prior to placing the ice
machine on the bin.
Install the bin top adapter or ice dispenser adapter,
if one is required for the application.
If the ice machine has not been unpacked, do so
now. Remove the carton from the skid. Lift the ice
machine off the skid directly onto the bin.
Note: The machine is heavy. Use a mechanical lift
if necessary.
Secure the ice machine to the bin with the
hardware provided (two metal straps and four
bolts).
Place the bin and ice machine in the selected
location and level it using the bin leg levelers.
June 2007
Page 8
C0522 through C1030
Remote Condenser Models - Installation Manual
