CLEANING
Remote Condenser
1. Shut off the ice machine.
2. Remove dirt and debris that might be under the
condenser.
3. Brush off the bottom of the condenser fins. Do
not use a wire brush.
4. Check to see that the inside of the condenser is
clean; light should be visible through the fins. If
not, clean the internal parts by vacuum, pressure
washer and/or coil cleaner.
Ice Storage Bin
The interior liner of the bin is in contact with a food
grade product: ice. The storage bin must be
cleaned regularly to maintain a sanitary
environment. Once a week cleaning of the door &
frame with soap and water, a hot water rinse and
and air dry is a basic procedure. Scale that may
form on the plastic liner of a bin may be removed
by scrubbing the surface of the line with a mixture
of Scotsman Ice Machine Cleaner and hot water.
Remove any scale prior to sanitizing.
Inlet Water Valve
The inlet side of the water valve has a screen in it
to protect the internal components from debris that
may be carried to the valve by the water. If the
screen becomes clogged, it must be cleaned off.
1. Shut off the water supply.
2. Unplug electrical connector from the valve.
3. Dismount valve from cabinet.
4. Remove inlet connection from valve.
5. Brush debris from
sceen.
6. Reverse steps 1-4 to
reassemble.
To remove scale:
1. Mix a cleaning solution of 4 ounces of Scotsman
Ice Machine Cleaner to 4 pints of hot (95
0
F. to
110
0
F.) water.
2. Remove all ice from the bin.
3. Using rubber gloves, dip a nylon scouring pad
into the cleaning solution, and scrub the scale off
of the liner.
4. After the scale has been removed, rinse all of
the surfaces inside the bin with clean, potable
water.
To sanitize the bin and ice machine:
Follow local codes for frequency of sanitizing. Use
an approved sanitizer and follow the directions and
warnings of that sanitizer or use the following
instructions for use of household bleach, if it meets
local codes:
1. Remove all ice from the bin.
2. Mix a sanitizing solution of 1 ounce of
household bleach to 2 gallons of water.
3. Using clean rubber gloves and a clean cloth,
wipe all interior surfaces of the ice machine and
ice storage bin with the sanitizing solution.
Immerse any small parts in the sanitizing solution
and wash the parts, flushing the solution
thoroughly in, over and through all parts and
surfaces of the parts being cleaned.
4. Allow to air dry.
The fan blade can
cause personal injury.
Disconnect power
before beginning to
clean condenser.
Scotsman Ice Machine
Cleaner contains acids.
These compounds may
cause burns.
If swallowed, DO NOT
induce vomiting. Give
large amounts of water
or milk. Call Physician
immediately. In case of
external contact, flush
with water.
KEEP OUT OF THE
REACH OF CHILDREN.
SCREEN
INLET
WATER
VALVE
CME1202R & CME1402R
June 1996
Page 20
