To Adjust The Rear Wheel Height
1. Using a
1
4
“ socket wrench, remove the seven
screws from the rear access panel and carefully pull
the panel away from the drain hose.
2. Using a
3
8
“ or adjustable wrench, remove the
screw that holds the rear wheel.
NOTE: Pushing up against the top back of the ice
maker takes some of the weight off of the wheels.
This makes it easier to remove the screws.
3. Move the rear wheel and screw to a new position
as needed for your cabinet opening height. Tighten
the screw completely.
4. Repeat Steps 3 and 4 to change the position of
the wheel on the other side.
5. Replace the rear panel and screws. Be sure that
the drain tube is positioned in the opening provided.
6. Use the front leveling legs to make sure the
product is level.
To adjust the front leveling legs
Your ice maker has two adjustable leveling legs to
help you steady the product and make sure it is
level.
SUGGESTION: It is easier to adjust the leveling legs
if you have another person to assist you.
1. Place a carpenter’s level on top of the product to
see if the ice maker is level from front to back and
side to side.
2. Push up on the top front of the ice maker, and
then locate the leveling screws that are on the
bottom front of the product.
3. Using an adjustable wrench, change the height of
the legs as follows:
•
Turn the leveling leg to the right to lower that
side of the ice maker.
•
Turn the leveling leg to the left to raise that side
of the ice maker.
NOTE: The ice maker should not wobble. Use shims
to add stability when needed.
4. Use a carpenter’s level to re-check the ice maker
to see that it is even from front to back and side to
side. If the ice maker is not level, repeat Steps 2 & 3.
If the ice maker is level, go to the “Connecting the
Ice Maker to a Water Source” section.
Freestanding Installation
If you are not installing your ice maker under a
countertop, you will probably not need to adjust the
rear wheel height. Follow the steps outlined in “To
adjust the front leveling legs” earlier in this section.
NOTE: The ice maker should not wobble. Use shims
to add stability when needed.
July 1999
Page 5
CSW45
Electrical Shock Hazard
Failure to follow these
instructions can result in
death, fire, or electrical
shock.
Disconnect power before
servicing.
Replace all panels before
operating.
