CU50
Installation and User’s Manual
March 2010
Page 10
Electrical
The ice machine is supplied with a power cord.
Do not remove the grounding pin from the cord’s
plug. Do not use extension cords. Follow all codes.
Connect the machine to its own 115 volt, 15 amp
circuit.
1. If the electrical outlet for the ice maker is
behind the unit, plug in the unit.
2. Position the unit in the installation opening.
3. Turn on the water supply. Make sure that the
ice maker is plugged in and the power is on.
4. Slide unit into installation opening, paying
careful attention to water supply and drain
connections. Do not kink!
5.
Pour a couple of quarts of water into the ice
storage bin; on drain pump equipped machines
the drain pump should start and water should
pump out. Check for leaks.
6. Replace the service access panel.
7. Level the unit as needed.
Back View, Gravity Drain Model
Drain Hose
Barbed Elbow
Drain Hose,
Route to
building drain
Water Inlet
Tube (field
supplied)
