11
OPERATING INSTRUCTIONS
Power Function
Flame Brightness Function
Temperature Function
M
M
To use the remote control,
first insert two AAA batteries
(included) into the remote
control. Ensure the polarities
of the battery match the inside
of the battery compartment.
Note:
The control panel is a touch screen. It will appear black. Touch the control panel once to
“wake up” the controls. This will cause the controls to light up. Which ever icon you touch will display
it’s last setting when you do this. At this time you can press the corresponding icon to the function you
would like to adjust. After 5 seconds the touch screen will fade to black.
• Press the TEMPERATURE ICON to adjust the heater’s thermostat setting.
• If the unit is powered OFF, you can press the TEMPERATURE ICON to power ON the unit.
The emberbed will glow at the lowest brightness setting unless a different setting was saved
in the memory.
• Press the TEMPERATURE ICON again to scroll up through the pre-set temperature settings:
The thermostat setting range is 65°F (18°C) to 90ºF (32°C), HI (High) and OFF.
• Set the temperature to "HI" to have the heater run continually.
• Press and hold the TEMPERATURE & TIMER ICON for 5 seconds to toggle between 5°F
(3°C) increments and 1ºF (1°C) increments when setting the temperature. The unit will beep to
indicate that the change has taken place. The factory default temperature is 5°F (3°C) increments.
Note: This option is only available if using the control panel.
• Hold down the TEMPERATURE ICON for 5 seconds to toggle between Fahrenheit and Celsius.
An “F” or “C” will display next to the temperature.
Note: This option is only available if using the control panel.
• Press and hold the TEMPERATURE ICON for 10 seconds to disengage the heater function.
Press and hold the TEMPERATURE ICON for 10 seconds again to engage the heater
function. (See HEATER OVERRIDE section below for more details).
• Press the POWER ICON to turn the main power to the unit ON or OFF.
• When the unit is powered ON, the lights under the emberbed will glow to indicate the unit
has power.
• If any functions are stored in memory then they will resume at the last setting .
• Press the FLAME BRIGHTNESS ICON to adjust the flame brightness.
• If the unit main power is OFF, you can press the FLAME BRIGHTNESS ICON to power ON
the unit and flame brightness will resume at the last setting.
• Press the FLAME BRIGHTNESS ICON again to scroll up through the flame brightness
settings: 1, 2, 3, 4, 5, OFF.
Control Panel
Remote Control
