OPERATING INSTRUCTIONS
12
Control Panel
Remote Control
To use the remote control,
first insert two AAA batteries
(included) into the remote
control. ensuring the poplarities
of the battery match the inside
of the battery compartment.
Note: The control panel is a touch screen. It will appear black. Touch the control panel once to
“wakeup” the controls. This will cause the controls to light up. Which ever icon you touch will display
it’s last setting when you do this. At this time you can press the corresponding icon to the function you
would like to adjust. After 5 seconds the touch screen will fade to black.
Power Function
• Press the POWER ICON to turn the main power to the unit ON or OFF.
• When the unit is powered ON, the lights under the emberbed will glow to indicate the unit
has power.
• If any functions are stored in memory then they will resume at the last setting.
Flame Brightness Function
• Press the FLAME BRIGHTNESS ICON to adjust the flame brightness.
• If the unit main power is OFF, you can press the FLAME BRIGHTNESS ICON to power ON
the unit and flame brightness will resume at the last setting.
• Press the FLAME BRIGHTNESS ICON again to scroll up through the flame brightness
settings: 1, 2, 3, 4, 5, OFF.
Temperature Function
• Press the TEMPERATURE ICON to adjust the heater’s thermostat setting.
• If the unit is powered OFF, you can press the TEMPERATURE ICON to power ON the unit.
The emberbed will glow at the lowest brightness setting unless a different setting was saved
in the memory.
• Press the TEMPERATURE ICON again to scroll up through the pre-set temperature settings:
– Fahrenheit: 65, 70, 75, 80, 85, 90, HI, OFF.
– Celsius: 18, 21, 24, 27, 29, 32, HI, OFF.
• Set the temperature to “HI” to have the heater run continually.
• Hold down the TEMPERATURE ICON for 5 seconds to toggle between Fahrenheit and Celsius.
An “F” or “C” will display next to the temperature.
• Press and hold the TEMPERATURE ICON for 10 seconds to disengage the heater function .
Press and hold the TEMPERATURE ICON for 10 seconds again to engage the heater
function. (See HEATER OVERRIDE section below for more details).
M
M
M
M
8:88
