22
CHAPTER 3: CONFIGURATION AND SETUP
087-0067 REV A
SCOTT SAFETY
Using the HMI
The HMI screen is the interface through which various levels of operators can monitor
important parameters and configure, the compressor, and/or charge units of the
system. When any parameter values are out of normal operating range, the HMI
outputs alerts to the user, suggest possible actions or shutdown the unit depending on
the severity of the alert condition.
Warning: Never leave the Stationary Air Compressor system unattended while the
compressor is in use. A Scott trained and certified operator must monitor the system
gauges at all times and take immediate action to guard against equipment failure.
This equipment is intended for providing breathable air to save lives. Failure to
monitor the system may lead to permanent equipment damage, serious personal
injury or death.
Caution: Hearing protection may be required when using the Stationary Air
Compressor system for extended periods of time. Refer to the personal safety
guidelines or requirements of your organization. Exposure to high sound levels may
cause temporary or permanent hearing loss in some individuals.
Warning: Training is required before use of this equipment. Improper use of this
equipment may result in serious injury or death. Improper use includes, but is not
limited to, use without adequate training, disregard of the warnings and instructions
contained herein and failure to inspect and maintain this equipment.
The menu screens in this chapter are based on the HMI’s Firmware
.
Version 1.10. If
your device has a different firmware version, then the menu screens will vary.
Warning: Configuration should be performed by trained individuals who have read
this manual and understand the calibration procedures. Failure to follow these
instructions may result in serious injury or death.
Warning: When settings are changed, ensure those changes are communicated to all
affected personnel.
Summary of Contents for HushAir Connect 7500
