MG984G
-3
6
M
1
You can either input your relevant Cellular Network Providers Parameters manually into the camera
or you can download the setup application program
BMC CONFIG
_CAMERA_TRAPScc
.exe
and save it
to your PC / laptop which has all these parameters pre-installed and you can also change the camera
settings.
This
BMC CONFIG
_CAMERA_TRAPScc
.exe
setup program creates a folder (called 'GSM') which will
need to be copied to your SD card and put back into the camera to update it (explained after MANUAL
INPUT below).
1
.
MANUAL INPUT
(directly into the camera)
•
Connect camera to correct power source before turning to SETUP
8 x Alkaline or Lithium batteries OR
8 x AA size Nickel Metal Hydride (NiMH) rechargeable batteries (min 2600 mAh) OR
1 x DC 6-Volt, 2A external SLA rechargeable battery or 6v solar panel
•
Insert a clean (formatted) SD card into the camera (maximum of 32GB)
•
Insert the your preferred cellular network provider's SIM card into the camera - Please disable the SIM PIN.
(Please ensure sufficient Airtime / Data has been loaded onto the SIM card)
Indicates the SIM card is recognized by the camera.
Indicates the SIM card is not recognized by the camera or the SIM card is not working due to connection/
activation issues.
Turn the camera power button to
SETUP
. Make sure the SIM card is recognized and signal
strength is adequate.
1. Press MENU.
2. Set your preferences (Photo / Video / Pic+Video)
- please note that only vido clips (up to 10MB can be
sent via Email GPRS and Molnus.
3. Set Photo Size
(this size gets saved tho the SD card - you get sent minimised versions (+/- 60kb) for fast
transmission.
4.
Set Video Size / Photo Burst (images per activation required - up to 5) and Video Length (up to 180 sec)
5. Press MENU to get out of this screen and Press the right arrow to go to the next MENU option
6. Set these parameters to your preferences
7. Go to the next MENU item to select the Send Mode
Molnus (the FREE Cloud service) is default.
This is explained in the Sending via Molnus document.
Select your send mode preference and fill in the correct parameters manually using the keypad buttons
