09
6. Assembly and setup
1. Open the kickstand
2. Loosen the knob of the folding mechanism by turning it counter-clockwise, lift the handlebar
stem, then tighten the knob of the folding mechanism by turning it clockwise.
3. Install the handlebar on the stem, insert/screw in the four screws but do not tighten them.
4. Tighten the four screws.
6. Adjust the braking system if necessary (chapter 9)
7. Check the tyre pressure (30 PSI) both before the first use and periodically
(every 2-3 weeks).
After performing these operations, power up the electric scooter to make sure that everything
is working.
