04
2. Quick guide
• Fully charge the scooter before using it for the first time.
• Activate the electrical circuit, press the power button for a few seconds to start it.
• Check the battery indicator: if the battery is dead, charge it before use. The electric scooter is
a device that needs to be charged periodically to be able to work.
• Check the tyre pressure (30 PSI); if the electric scooter does not reach at least 60% of the
declared Km or does not reach the maximum speed within the first 3 months of use, it is likely
that the wheels have deflated again. In this case, restore the pressure as indicated.
• Place the electric scooter on a flat surface.
• Place your hands on the handlebars. Step onto the footrest with one foot and use the other
to give yourself a gentle push and accelerate.
• When the electric scooter begins to move, place both feet on the footrest and
press the accelerator.
• To steer the electric scooter, tilt your body in the direction of travel when turning
and slowly turn the handlebar.
• To stop the electric scooter, release the accelerator and press the electronic brake
or lever on the left side of the handlebar.
• Stop the electric scooter completely before getting off. Trying to get off the electric
scooter while it is moving may result in injury.
• To change the speed mode, press the on/off button twice quickly (button B in chapter 5).
• When riding at night or in dark places, press the power button once to turn on the lights,
wear a reflective vest.
For your own safety, wear a helmet and knee pads to protect yourself against falls and injuries
while learning to ride the electric scooter.
The rider assumes all responsibility for any injury suffered when not wearing a helmet or other
protective gear.
The accelerator is activated once the speed of travel exceeds 3 km/h.
For safety reasons, the electric scooter is initially set up to avoid standing starts.
IMPORTANT
