5
IN
AU
STRAL
IA
PR
OU
DLY BUILT
Continued Over.../
INSTRUCTIONS -
INTERFIT
PROJECTOR LIFT – FVI and HTI Series
3. INFRA-RED INPUT
•
Supplied with 2 channel IR transmitter
•
Supplied with IR receiver with 300mm and 1.2M input lead
•
IR operates on Group 1 default – can be changed in set up
4. RJ45 LAN INPUT
•
DHCP or Static IP addressable
•
Internal Web Browser
•
TCP/IP controllable
•
DHCP as standard
5. 240 VOLT INPUT
•
Connection with supplied IEC power cable
6. 240 VOLT OUTPUT TO MOTOR
•
Connected by supplied WAGO connector
•
Wiring
- Pin 1 – Brown
- Pin 2 – Black
- Pin 3 – Yellow/Green – Earth
- Pin 4 - Blue – Neutral
IP OPERATION OF MOTOR CONTROLLER
7. PC OR MAC CONNECT SOFTWARE
•
As the motor controller is DHCP default, this software will allow simple operation and
identification of DHCP IP address allowing for operation and programming
•
Connect motor controller to network
•
Run PC Connect or Mac Connect software -
•
Software looks for Connect IP products on the network (Maximum 2)
•
Screen shot below showing that software has found IP connect motor controller showing
allocated IP Address
•
Connect to module using “connect button”
•
Screenshot below shows GUI screen
- Lifter can be operated from this GUI
- Status shows current position
•
GUI shows IP address, port number and command structure for commands
•
UP command is IP address, port number 30 1
•
Software updates string after all commands
f.
Connect to module using “connect button”
g.
Screenshot below shows GUI screen
i.
Lifter can be operated from this GUI
ii.
Status shows current
position
h.
GUI shows IP address, port number and command structure for commands
i.
UP command is IP address, port number 30 1
j.
Software updates string after all commands
f.
Connect to module using “connect button”
g.
Screenshot below shows GUI screen
i.
Lifter can be operated from this GUI
ii.
Status shows current
position
h.
GUI shows IP address, port number and command structure for commands
i.
UP command is IP address, port number 30 1
j.
Software updates string after all commands
f.
Connect to module using “connect button”
g.
Screenshot below shows GUI screen
i.
Lifter can be operated from this GUI
ii.
Status shows current
position
h.
GUI shows IP address, port number and command structure for commands
i.
UP command is IP address, port number 30 1
j.
Software updates string after all commands
8.
Simple web browser operation
a.
Selecting browse button on GUI opens simple control web browser page
b.
Screen or Lifter can be operated from this page
8.
Simple web browser operation
a.
Selecting browse button on GUI opens simple control web browser page
b.
Screen or Lifter can be operated from this page
