9
IN
AU
STRAL
IA
PR
OU
DLY BUILT
OPERATE IR GROUP
OPERATE SWITCH GROUP
Continued Over.../
IR GROUP COMMANDS
•
Each module will require programming via register 75, as per point 15 in document
•
Example of direct command Connected to 192.168.0.32:3002 – command 20 1 ,would see all
lifter programmed to operate on IR group 1 move to up position
SWITCH GROUP COMMANDS
Example of direct command:
•
Connected to 192.168.0.32:3001 – command 30 1 using module ID would see the lifter move
to up position
•
Connected to 192.168.0.32:3001 – command 30 17 using MAF address would see the lifter
move to up position
COMMAND
IR GROUP
DESCRIPTION
20
IR Group 1 or 2
Operate IR Group UP
23
IR Group 1 or 2
Operate IR Group DOWN
26
IR Group 1 or 2
Operate IR Group STOP
INSTRUCTIONS -
INTERFIT
PROJECTOR LIFT – FVI and HTI Series
18. MODULE STATUS FEEDBACK
•
A module status buffer (20 record FIFO) is updated as a automatically generated Send
Register Commands with register number = 0x20 are sent from each module.
The module status buffer contains the Module ID (1 byte), and Module Status (2 bytes)
COMMAND
050
COMMAND
VALUE 1
VALUE 2
VALUE 3
150
Status
Module ID
Module Status Register (0x20)
Response from module e.g. 150, 1, 1, 6 – value 6 indicates screen at top
Note:
Status=1 is returned if valid data and no further records in the status buffer
Status=2 is returned if valid data and there are still records in status buffer
Status=3 is returned if valid data but the buffer is full (eg may have lost data)
Status=6 is returned if there are no new records
This buffer is updated when screens are moved. It is also updated automatically every 60 seconds.
It needs to be polled regularly to clear the stored data otherwise it will get full and records will be
lost. Even though screens may not be moving the data is being updated even though the status is the
same.
RESPONSE TYPE NO
CONNECT IP MODULE
0
Moving top
1
Moving bot
2
Moving PP1
3
Moving PP2
4
Moving PPT
5
Moving PPB
6
At TOP
7
At BOTTOM
8
At PP1
9
At PP2
10
Stopped manual
11
Error
12
Spare
13
Fail-timeout
14
Fail – current
15
Rattle
16
At PPT
17
At PPB
COMMAND
IR GROUP
DESCRIPTION
10
SWITCH Group 1 or 2
Operate Switch Group UP
13
SWITCH Group 1 or 2
Operate Switch Group DOWN
