Line assembly
Pass the first glass through the washer either on its base or on
its height. Position the assembled kit on the first glass, ensu-
ring that the head rail is on the top or on one side. During this
operation, it is recommended great care is taken with the inte-
gral blind, in order to avoid any dirt or damage to the fabric.
Position the spacer frame uniformly on the glass ensuring it is
perfectly parallel and square (avoiding any inwards deflection
of the side spacer bars) and press to obtain a high degree of
adhesion. Proceed with the assembly of the second glass and
pass through the on-line pressing system.
Gas filling
Using the appropriate equipment and in accordance with the
standard procedure replace the internal air with argon.
Testing
After the press operation but prior to applying the final seal,
test the blind function’s using the appropriate power supply /
switch - ensuring that the double-glazed unit is positioned ver-
tically with the blind head rail at the top. Check that the bot-
tom rail reaches the lower spacer bar. We do not recommend
other kinds of electrical devices as power supplier or control.
At the end of the test, raise the blind completely to the top,
and insert the silicon tubes to protect the contacts /connectors
from secondary sealant.
assembly instructions
11
first sealing applying
blind insertion on the spacer bars
SL27M plissé_GB 15-05-2007 9:29 Pagina 11
