- 43 -
EN
6
43
Register
button
Call
button
Part Two: Wireless Doorbell
1. To register
Call
Register
Register
Register
Before using the outdoor station, you should first register it to the base unit. First, you should hold the
key on the bottom of the base for 5 seconds or longer then release it. Second, please press the
button of the outdoor bell then hold the
key on the back of the outdoor unit for 5 seconds or
longer then release. Please remember to remove the small rubber case which is sticked on the
key of outdoor station. If you still can not register successfully, you can try to turn off the power of the
base and remove the batteries from the outdoor unit before you hold the
key then turn on the
power, install the batteries and then try again. After you hear a prompt tone, the station has been
registered to the base successfully. Please see the figure below for details.
Phone Layout and Keys Function (continued)
Rear View
Call button
Outdoor station
1. 12V DC Positive input
2. 12V DC Negative input
3. Lock control positive terminal
4. Lock control negative terminal
5. Silica gel plug
1
2
3
4
5
