SCS CTM048-21 EM Eye, User Manual

TB-9023

 Page 13 of 16

© 2017 DESCO INDUSTRIES, INC.

Employee Owned

SCS 

- 926 JR Industrial Drive, Sanford, NC 27332 • (919) 718-0000 • Website: 

StaticControl.com

Figure 35. Locating the Data Storage button

EM FIELD Data:

(EM field meter) (Units) (Interval) 

(Average) (Date) (Peak) (Average 

record) (Time)

POWER DENSITY Data:

(Power density meter) (Interval) 

(Average) (Reference) (Date) (Peak) 

(Average) (Time)

EIRP Data:

(EIRP meter) (Distance) (Interval) 

(Average) (Date) (Peak) (Average 

record) (Time)

Data from the microSD card can be exported using 

utility software described in the data software section.

RF Signal Sensor Display and 

Controls

Menu Function

When the MENU F button is pressed momentarily, the 

INTERVAL and AVERAGE data recording timing can be 

configured.
INTERVAL, in seconds, is the sampling time for PEAK 

data to be recorded onto the microSD storage card.
AVERAGE, in seconds, is the sampling time for 

AVERAGE data to be recorded onto the microSD 

storage card.

When the MENU F button is pressed for a longer period, 

the hardware setup is shown. At this point, brightness, 

off-time and attenuation can be adjusted.
Attenuation (ATT): If the input to the antenna is big 

enough, set the attenuation from 0 to 20dB.
When the attenuation is set to 20dB, an additional 

label of “20dB” is placed along with the “RF Signal” top 

heading.

Figure 36. Using the Menu F button

Figure 37. Accessing the Hardware Setup menu

Figure 38. Changing the units of measure

Figure 39. Adjusting the RF Reference settings

RF Units of Measure

When pressed, the units area toggles between dBμV, 

dBm and mV units. dBμV –> dBm –> mV

Bar Graph/Reference Display and Button 

When the bar graph area is pressed, you can set the 

reference level for RF measurement.
With the NAVIGATOR bar:

Press the left or right arrows to adjust RF references.

Press the up or down arrows to move the field cursor.

Press the center button to return to the main screen.
Reference options:

1.  Memory Reference

2.  Current Reference

To choose between Memory or Current reference, press

“V” (enable) or “X” (disable) at the right side of display.