17
Web Setting Function:
System provide detail settings over web browser, you could input the IP address of transmitter /
receiver at link column of browser if you know the exact IP address of them.
There are four ways to get the IP address of receiver:
1. Connect monitor with receiver,
local IP
shows on right bottom screen when receiver booting or
transmitter not connected( or no video input)
2. Press remote control button
MENU, 1, ENTER
(IP Address), it will shows the receiver IP
Address on screen
3. Install Internet explorer plug-in: Bonjour , click device name to enter web setting page to get the
IP address(please refer Bonjour plug-in installation)
4. Run
“
Device Manager
”
program in CD, enter the Client page(please refer software instruction)
There are four ways to get the IP address of transmitter:
1. Connect monitor with receiver, connect receiver with transmitter and set in the same
channel,
remote
IP
shows on right bottom screen when receiver booting or no video input from
transmitter
2. Connect monitor with receiver, connect receiver with transmitter and set in the same
channel, press remote control button
MENU, 2, ENTER
(Host IP Address) at receiver side, it will
shows the transmitter IP Address on screen(must remove the HDMI cable of transmitter or turn
off the video source).
3. Install Internet explorer plug-in: Bonjour , click device name to enter web setting page to get the
IP address(please refer Bonjour plug-in installation)
4. Run
“
Device Manager
”
program in CD, enter the Host page(please refer software instruction)
System default IP setting is Auto IP, it will assign 169.254.X.X (subnet mask 255.255.0.0) to
transmitters and receivers, you could also set to DHCP or Static IP.
You computer must set in same subnet mask to enter the web setup page.
If you do not sure the IP address of transmitters/receivers you could reset the transmitters and
receiver to default.
For transmitters: press the LINK button to power on (Press and hold until Green and Blue LED
Flash) to reset to default.
For receivers: press remote control
MENU,
3,
3,
3,
ENTER
to reset to default.
