7
Cable & Transmission Distance:
Link Cable use high quality Cat.5e UTP/STP/FTP or Cat.6 UTP cable
Transmission distance will be affected by equipment (Switch HUB), cable quality
…
etc.
When using CAT.5e cable connect transmitter and receiver directly without Ethernet switch, the
maximum transmission distance up to 150M, using CAT.6 cable up to 180M.
You can also use model no: SR01 repeater for extended longer distance or using Gigabit Switch
hub which support
IGMP
protocol and
Jumbo Frame 8K
for signal distribution or extend distance.
System Default Settings:
Transmitter / receiver support
Unicast
and
Multicast
two mode, default is Multicast.
In Multicast mode it could be one to one, one to multi, multi to on or multi to multi applications.
The analog audio output of transmitter and input of receiver will be off in this mode, analog audio
only from transmitters send to receivers.
Unicast mode suitable for one to one or multiple transmitters to one receiver applications.
Analog audio bi-direction transmission only in
Unicast
mode, please refer to the web setting
chapter: Casting Mode
System default IP setting is
Auto IP
, it will assign
169.254.X.X
(submask
255.255.0.0
) to
transmitters and receivers, you could also set to DHCP or Static IP, please refer to web setting
chapter: IP Setup.
Bandwidth Chart:
The bandwidth will be varied based on different resolution. Higher resolution may not request
bigger bandwidth. Below Chart is the resolution and bandwidth status for reference.
Resolution (@60Hz)
Average Bandwidth
(Mbps)
Resolution (@60Hz)
Average Bandwidth
(Mbps)
1080p
77 (24 ~ 91)
1600x1200 (UXGA)
59 (24 ~ 73)
720p
46 (29 ~ 150)
1280x1024 (SXGA)
58 (31 ~ 76)
480p
63 (36 ~ 73)
1024x768 (XGA)
118 (56 ~ 138)
800x600 (SVGA)
83 (64 ~ 107)
Above bandwidth chart not include USB transmission, it cost up to 50 Mbps when transferring mass
data.
System support 16 full HD video source transmitted simultaneously, for more than 16 video sources
can be set through web page or APP.
System scalability is limited only by uplink and stacking connector bandwidths, for example under
Gigabit Ethernet network, the total flow must not exceed 1000Mbps to avoid any delay on video
streaming. If the video play with 1080p resolution, the transmitter allow maximum up to 10pcs for
simultaneous video streaming.
For 11~20 sources: use switches which support 802.3ad Link Aggregation or smart (or intelligent)
switches to get 2 Gbps or more bandwidth.
For 21~100 sources: use switches which support SFP+ uplink or stackable switches to get 10 Gbps
bandwidth.
USB Hot Key Function:
In multicast mode support multi USB keyboard and mouse in each receivers, just plug and play, but
only one USB FLASH drive / hard disk could be used at same time.
You have to click
“
Pause/Break
”
key three times of the keyboard on the receiver to establish USB
FLASH drive /hard disk connection.
(Not available for HE05BT/HE05BR/HE05BER)
