Chiller wired controller
4) Adjust the length of two plastic screw bars in the accessory to be standard length from the electrical
box screw bar to the wall. Make sure when install the screw bar to the electrical box screw bar, make it as
flat as the wall.
5) Use cross head screws to fix the wire controller bottom cover in the electric control box through the
screw bar. Make sure the wire controller bottom cover is on the same level after installation, and then
install the wire controller back to the bottom cover.
6) Over fasten the screw will lead to deformation of back cover.
5. Wiring
1) Wiring, three out letting positions
86
Electrician
box
Back cover
Signal switching
wires
Cutting place of left
down side wire outlet
